Case, please repack in the same manner

First take out clamp and column

Must be a VERY stable table over 1 1/2 inches in thickness (NO PLYWOOD) and must not have anything under the table or the clamp will not fully fit on the table.

Clamp tight to table

Attach Power Supply to Column, can use black levers to tighten on column

Attach Arm to Power Supply, back out black lever if post does not fit into the power supply, same for power supply

AttAch Coupling Piece, again back out black knob if post does not fit into arm

Bottom of microscope with screws attached. The screws are in the handles

Attach Handles

Attache Microscope to Coupling Piece. Make sure knob and rod inside allows you to attach scope, if not just rotate knob. Also if small screw is turned in it must be turned out until microscope attaches.

These black knobs attach to top of swivel arm and back of coupling piece

Fiber Optic Cable goes here and the back of the microscope.

This is where the bulb is on the power supply. Squeeze by fiber optic cable to release this unit.

Squeeze the two sides by the fiber optic cable to release this unit.

Attach Beam Splitter and tighten with thumbscrew. Note on the microscope body the black knob with numbers, this is the mag. changer.

Attach Stereo Observation Tube in notches. Large black lever will loosen the axis of the tube, while the black wheel is for rotation of the image.

Attach Binocular Tubes and tighten with thumbscrews.

This black lever will tighten the arm, but is should be balanced so only slight friction will be fine.

This is what the scopes looks setup. It should be places on the side of the table or opposite side of the table. The blue knob is for small fine focus, but most focus is just up and down of the arm.